Pull out the parts of your Kit. This will include: 3D printed “Badge”, CR2032 Battery, Magnetic Backing, and 5mm Color Change LED

IMG_20160515_133812
Locate the LED and CR2032 Battery and Open The package.
IMG_20160515_133939
Find the Orientation of the LED that lights up against the two sides of the Battery. (This should be the long side of the LED on the “+” side and short n the unmarked side.
IMG_20160515_134006
Fold the Side out of the LED at the base of the LED.
IMG_20160515_134200
Fold the next part in on the Indent of the LED Lead (wires).
IMG_20160515_134332
Lift the Right LED lead wire and slide in the CR2032 Battery with the “+” side down. Then, shove the LED down into the slot, this will create a pressure fit.Touch the other side of the LED lead to the unmarked side and watchit light up.
IMG_20160515_134413
Grab the Magnetic Backing and take off the sticky tape protector, Align with the Top of the Badge covering the LED.
IMG_20160515_134436
Attach to Shirt and enjoy! Battery is replaceable by any CR2032 and can be purchased at most convience stores, pharmacies, and supermarkets.
IMG_20160515_134530

Categories: 3D Printing

0 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *